![]() In all cases I was able to push the end of the chisel under the gripper a little by hand, and then work the nail out. ![]() If the gripper is really tight on the floor board you might need to hammer the chisel gently to get it below the gripper, but I never needed to do this. The using the other chisel as a fulcrum I slowly levered the nail out. The method I used was to start at one end of a carpet gripper machine and push the sharp end of the chisel under the first nail. I’ve had some that have shot up well above the height of my face when they suddenly pop out of the floor. They are covered in sharp nails, and they can fly off the floor when levered up. ![]() In this case you really should – especially when removing smaller strips of carpet gripper. A lot of DIY guides say to use safety glasses but of course you never do. I used a smaller chisel but I could have used anything of similar size and solid such as a screwdriver or piece of wood or metal. Another item to use as a fulcrum under the first chisel.A chisel with a fine sharp end that could get under the carpet gripper.Here is how I removed the carpet grippers in one room. If you are completely re-doing the flooring of a room (to go from carpet to wood flooring, or to lay sound proofing for example) you might need to remove the old carpet grippers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |